|
|
« Last Page | viewing entries 1-15 of 423 |
Next Page »
|
Length: 4:58 -
Rating: 4.9506173 (81 ratings) -
View: 14059 -
Author: W0ZF
How to build a simple and cheap portable vertical antenna for the 20m Amateur Radio band. Antenna is built using a fiberglass telescopic fishing pole and som...
Tags
|
|
Length: 1:28 -
Rating: 0 (0 ratings) -
View: 3 -
Author: Danilo Grapa, Jr.
Here is my repair table. It is pretty much my radio shack also. I repair laptops and make ham radio antennas on this hardare. It was previously my bed that I...
Tags
|
|
Length: 1:18 -
Rating: 5.0 (18 ratings) -
View: 10164 -
Author: machineman97
How to install a Breedlove Mount stake pocket bracket for cb or ham radio antenna mount on your pick up truck. A solid brass EZ over antenna mount is also sh...
Tags
|
|
Length: 2:36 -
Rating: 0 (0 ratings) -
View: 78 -
Author: Greywolf's Channel
My poor ham radio antenna got a bit bent in the wind, this was February 24th, 2011. Why do I live in Minnesota?.
Tags
|
|
Length: 5:52 -
Rating: 4.714286 (14 ratings) -
View: 6722 -
Author: TimTools99
The primary rule for protecting ham radio equipment against lightning damage is connection of all elements to a SINGLE, low impedance grounding point.
Tags
|
|
Length: 5:2 -
Rating: 5.0 (8 ratings) -
View: 2127 -
Author: Wilson Hines
This is a video of the monster 265' amateur radio antenna built by Radio Works - http://www.radioworks.com/ccw160.html.
Tags
|
|
Length: 33:36 -
Rating: 4.8461537 (26 ratings) -
View: 1212 -
Author: Dave Tadlock
An easy to build ham radio 2 meter yagi antenna made with coat hangers.
Tags
|
|
Length: 1:56 -
Rating: 5.0 (1 ratings) -
View: 77 -
Author: Leighroy207's channel
First of 6 videos from the morning of 02.01.13. A Monster Duct formed during the night and these were some of the results. The best signals were before sunri...
Tags
|
|
Length: 0:34 -
Rating: 5.0 (3 ratings) -
View: 92 -
Author: zeekzilch's channel
I'm not sure how to explain this other than my antenna became covered with a thin layer of ice over an outer shield of insulation that slowly peeled off as t...
Tags
|
|
Length: 0:41 -
Rating: 3.0 (2 ratings) -
View: 844 -
Author: machineman97
From Breedlove Mounts , The EZN pick up truck stake pocket bracket Solid aluminum with stainless steel screws and a built in 4 degree angle to level the truc...
Tags
|
|
Length: 6:30 -
Rating: 5.0 (3 ratings) -
View: 228 -
Author: SpuriousEmission's channel
Barrak, 9K2UU in Kuwait talking to American radio amateurs on the twenty meter (14Mhz) band transmitting on upper sideband (USB). Surprisingly, I was able to...
Tags
|
|
Length: 11:0 -
Rating: 4.428571 (7 ratings) -
View: 2144 -
Author: andy72xbox
I show how i installed my cb antennas and my PA speaker Re-uploaded: because i rendered it differently because the quality was too terrible. Yay for better q...
Tags
|
|
Length: 0:35 -
Rating: 5.0 (4 ratings) -
View: 3627 -
Author: mcphotolock1
Homemade 11meter, quarterwave, vertical antenna. The tower section is welded together from old bed frames. The antenna radials are made from discarded tent p...
Tags
|
|
Length: 2:4 -
Rating: 5.0 (9 ratings) -
View: 965 -
Author: NW7US
Reception of "The Voice of Greece" transmitting on 9420 kHz in the 31-meter band, on shortwave radio. The receiver is an Icom IC-7000 located in Omaha, Nebra...
Tags
|
|
Length: 6:11 -
Rating: 5.0 (5 ratings) -
View: 501 -
Author: Erik Storvik
New add-ons include: -Speco Industries 25W PA Horn (x2) -Cobra 29 LX CB Radio -Firestik Firefly 4' Antenna -Heavy Duty Antenna Spring -Firestik Quik-Disconne...
Tags
|
« Last Page | viewing entries 1-15 of 423 |
Next Page »
|
|
|
There was an error processing the request. Please try again.
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
;)
